Water has to be kept occasionally and for this large or tiny container or dispensers are required. Dispensers, help to store and maintain water cool. Sometimes some coolers malfunction and because of this, fixing the bottled water heaters is a must.
If the compressor is located non-functional, the electric receptacle for correct voltage and power should be checked with a voltmeter. It has to be verified that the wires in the wall cable are attached to both power terminals on the cold thermostat.
The continuity has to be checked and it needs to be ensured that the wires in the wall cable are attached to both power terminals on the cold thermostat.The electromechanical relay (EMR) are inexpensive, easy to use and allow the switching of a load circuit controlled by a low power.
The wiring harness could occasionally develop an “open” or disturbance of electric flow and it would have to be replaced if other electrical parts are satisfactory and functioning. It’s a good idea to double-check the relay, overload and PTC Starter and be assured they’re in working order, by running a continuity test.
The most common problem faced is when the compressor is practical but doesn’t cool the water. This is due to a gas flow inside the sealed system. Any indication of petroleum inside the cooler, suggests a reduction of the gas.
The bottled cooler condenser should be cleaned periodically and installed at least 2 -4 inches away from the wall for good air circulation. The bottled water cooler has to be cleaned frequently and placed away from the wall.